iFIT WEIDER PRO 8500 User Manual page 14

13. Insert a Guide Cap (33) upward into a Side Top
Frame (13). Set the Side Top Frame on the left
Weight Bar Guide (5) and insert it into the Left
Support (6).
Attach the Side Top Frame (13) to the left
Upright (3) and the Left Support (6) with two
M10 x 75mm Bolts (102), two M10 x 25mm
Screws (98), four M10 Split Washers (93), and
four M10 Washers (84). Do not tighten the
Screws yet.
Repeat this step with the other Side Top
Frame (13) and the right side of the weight
rack.
14. Insert an M10 x 68mm Bolt (90) through the left
Upright (3) and the Side Top Frame (13). Hand
tighten an M10 Washer (84) and an M10 Locknut
(79) onto the Bolt.
Repeat this step with the other Side Top
Frame (13) and the right side of the weight
rack.
15. Make sure that the Guide Cap (33) is inside
the left Side Top Frame (13).
Attach the Center Top Frame (14) to the Side
Top Frame (13) with two M10 x 93mm Bolts (97),
two 17mm Spacers (66), two M10 Washers (84),
and two M10 Locknuts (79). Do not tighten the
Locknuts yet.
Repeat this step with the right Side Top
Frame (not shown).
13
84
93
102
3
14
3
15
14
97
14
13
33
93
84
5
6
79
13
84
90
97
66
13
66
33
84
79
98