Seat Swivel Assembly - Bruno ELECTRA-RIDE III Installation Manual

INSTALLATION
SEAT SWIVEL PLATE ASSEMBLY
footrest bracket bolts
Sliding the seat swivel plate assembly
behind the footrest bracket
View after seat swivel plate assembly
is slide behind the footrest bracket
©2004,1998 Bruno Independent Living Aids, Inc.®
swivel plate adjusting bolts
upper charge
bracket
upper rail
end plate
1. Remove the support channel cover.
2. Remove the upper swivel plate
adjusting bolts (see illustration).
3. Loosen but do not remove the (2)
lower footrest bracket bolts.
4. Slide the seat swivel plate assembly
behind the footrest bracket (see illustration
to left).
5. Align the upper adjustment hole in the
swivel plate assembly with the
corresponding hole in the carriage.
6. Reinstall the swivel plate adjusting bolts.
7. Tighten all (4) M10 bolts.
8. Remount the support channel cover
using tyhe Velcro® securing strips.
9. Unplug the jumper/switch assembly from
P9 and P5 on the circuit board.
10. Plug in the seat harness.
11. Reinstall the shroud and footrest handle.
12. Install the upper rail end plate and the
charge bracket.
18
CRE-2100 NRUL 08-16-2004