Carriage Installation - Bruno ELECTRA-RIDE III Installation Manual

INSTALLATION

CARRIAGE INSTALLATION

1
2 3
remove (3) screws on each side
push down on lever, fold down footrest,
unscrew and remove lever
jumper/switch
(2)
(3)
(1)
(4)
(1) center wheel
(2) tape
(3) front guide plastic
(4) cog
©2004,1998 Bruno Independent Living Aids, Inc.®
1. Remove the main machine housing
shroud:
a. Push down the footrest lever to fold
down the footrest.
b. Unscrew and remove the footrest lever.
c. Remove (6) screws as shown (3 on
each side).
d. Slide the shroud off.
2. Carry the carriage assembly up the stairs
to the top of the rail.
3. Connect the jumper/switch assembly to
points P9 and P5 on the circuit board
(see illustration to left).
4. Temporarily tape the lower carriage on
an angle to match the slope of the rail
(see photo to left).
14
CRE-2100 NRUL 08-16-2004