Nice Era Fit Series Instructions And Warnings For Installation And Use page 9

5.9.2 - Memorising a second transmitter in "Mode II"
– This procedure memorises the new transmitter in "Mode II", regardless of the Mode in which the old to transmitter was memorised.
Before starting the procedure, bring the awning (or shutter) to the midpoint of its stroke.
01. (on the new transmitter) Hold the key to be memorised down for 8 seconds (for example: the n key), then release it (in this case the motor does not perform any
movement).
02.
03. (on the old transmitter) Briefly press the n key a certain number of times depending on the and you want to memorise:
1 pulse = step-by-step command
2 pulses = Open > Stop > Open > Stop > command...
3 pulses = command Close > Stop > Close > Stop > command...
4 pulses = Stop command
04. (on the new transmitter) Press the same key as you pressed in point 01 and hold it down while the motor performs 3 movements. Upon completion, release the
key. If the motor performs 6 movements, it means that its memory is full.
01
example
New
03
Old
04
same
01
New
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds.
5.10 - Memorisation of a climate sensor connected via radio
To perform the procedure you must have a transmitter ("old") already memorised in "Mode I".
Before starting the procedure, bring the awning (or shutter) to the midpoint of its stroke.
01.
02. (on the old transmitter)
03.
forms 6 movements, it means that its memory is full.
01
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds.
n key pressed and wait for the motor to perform 4 movements. Upon completion, release the key.
02
8
sec.
Old
x 1 = Ste-by-Step
x 2 = Open > Stop > ...
x 3 = Close > Stop > ...
0,5
sec.
x 4 = Stop
3
5
sec.
10 seconds and then release it (in this case the motor does not perform any movement).
n key, provided it has already been memorized.
02
"P1" "P1"
1 0
sec.
Old
4
5
sec.
?
10
sec.
END
03
X 3
0,5
sec.
.
1 /
2 /
3 /
4 /
. If the motor per-
"P1"
3
2
sec.
END
English – 8