Nice Era Fit Series Instructions And Warnings For Installation And Use page 10

5.11 - "RDC
tion automatically reduces the motor traction torque, based on the factory setting or the one adjusted by the installer with the following procedure.
– This function is active with the factory setting but is not applicable if the limit switches are programmed with the manual procedure (paragraph 5.6).
Before starting the procedure, bring the awning to the midpoint of its stroke.
01.
n and s keys pressed simultaneously and wait for the motor to perform 2 movements. Upon completion, release the keys.
02. s key a few times, depending on the level you want to set for the motor sensitivity:
1 pulse = level 1, standard sensitivity (factory setting)( * )
2 pulses = level 2, maximum sensitivity
3 pulses = level 3, medium sensitivity
dure. this way, the adjustment is completed without changing the factory setting.
03.
n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
01
5
sec.
03
3
5
sec.
5.12 - "FRT
This function is useful to eliminate the unsightly depression of the canvas that may form when the awning is open. It is activated by programming position "2" near the
limit switch "1".
when using the automation, the awning lowers to the lower limit switch "1" and then automatically raises to position "2" (the one programmed with the following pro-
cedure), stretching the canvas. The function also acts when a partial opening/closing manoeuvre is commanded. In these cases the awning stops in correspondence
to the height "H" programmed and then rises automatically until the canvas is taut.
• "
limit switch "1" and limit switch "0".
Before starting the procedure, bring the awning to the midpoint of its stroke.
01. Press the t key and wait for the motor to open the awning until limit switch "1".
02. n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
03. s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04. s key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
05.
06. n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
01
0,5
sec.
04
4
5
sec.
06
3
5
sec.
9 – English
4 pulses = level 4, minimum sensitivity
5 pulses = level 5, function deactivated
02
2
END
s key as many times as necessary (the awning will move a few millimetres every time the key is pressed; if the key
" .
02
"1"
5
sec.
05
"2"
"1"
END
.
x 1 = standard sensitivity( * ) x 1 = standard sensitivity( * )
x 2 = maximum sensitivity x 2 = minimum sensitivity
x 3 = medium sensitivity
x 3 = medium sensitivity
0,5
x 4 = minimum sensitivity x 4 = maximum sensitivity
sec.
x 5 = function deactivated x 5 = function deactivated
Note – When performing the procedure, at any time you can cancel it by keep-
ing the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not
press any key and wait 60 seconds for the motor to perform 6 movements.
t key). Note – the position with the canvas taut is position "2".
03
2
"2"
"1"
Note – When performing the procedure, at any time you can cancel it by keep-
ing the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not
press any key and wait 60 seconds for the motor to perform 6 movements.
-
. Note – If this does not occur, cancel the proce-
?
10
sec.
. When the function is activated,
" ". • "
3
5
sec.
1 /
2 /
3 /
4 /
5/