Nice Era Fit Series Instructions And Warnings For Installation And Use page 11

5.13 - Total or partial deletion of memory
This procedure allows you to choose under point 05 the data that you want to delete.
5.13.1 - Procedure performed with a transmitter memorised in "Mode I"
Before starting the procedure, bring the awning (or shutter) to the midpoint of its stroke.
01.
n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03.
n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04. t key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
05. • To cancel the entire memory
• To delete only the memorised transmitters
• To delete only the limit switch heights ("0", "1", "2", "S") and intermediate heights ("H")
you want to adjust the limit switch heights again, using a different procedure than the one used previously.
motor to perform 5 movements. Upon completion, release the key.
01
5
sec.
04
3
5
sec.
This deletion must be performed only when
you want to adjust the limit switch heights
again, using a different procedure than the one
used previously. Whereas, if you want to ad-
just heights with the same procedure, it is not
necessary to delete them from memory.
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.13.2 - Procedure performed with an unmemorised transmitter
Before starting the procedure, bring the awning (or shutter) to the midpoint of its stroke.
01.
02. n on an unmemorized tramsitter pressed for 8 seconds. Now release the button.
03.
04. Now run the procedure in paragraph 5.13.1.
01
OFF
2
sec.
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
s and t
02
2
02
ON
sec.
New
I – – – – – – – – – – – – – –> max 15 sec. – – – – – – – – – – – – –>I
3
5
sec.
05
all
data
5
sec.
05
only
5
sec.
05
"0"
"1"
5
"H"
sec.
03
OFF
8 2
sec.
.
.
n key pressed and wait for the
03
3
5
sec.
END
5
END
5
END
5
.
.
02
ON
01 02 03 04
Paragraph 5.13.1
I – – – –> max 60 sec. – – – –>I
.
05
END
English – 10