Nice Era Fit Series Instructions And Warnings For Installation And Use page 6

5.5 - Memorising the FIRST transmitter
Warning – Every time the motor is powered, 2 movements are performed if at least one transmitter and the limit switch heights are not in the memory.
01.
02.
n pressed and wait for the motor to perform three movements. Upon completion, release the key.
01
OFF
2
sec.
Note
will occur automatically when adjusting limit switches height ("0") and lower height ("1"); moreover, the rolling shutter will move in the "operator present" mode until the
limit switches are adjusted.
5.6 - Manual adjustment of upper limit switch height ("0") and
lower height ("1")
Warnings •
are performed if at least one transmitter and the limit switch heights are not in the memory.
5.6.1 - To adjust the UPPER limit switch ("0")
Before starting the procedure, bring the awning/shutter to the midpoint of its stroke (note – if the limit switches are not present, the motor will make 2 movements).
01. n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. n key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
03. s key pressed and wait for the motor to perform two movements. Upon completion, release the key.
04. Adjustment of the position: keep the s (or t) key pressed until the awning/shutter reaches the desired "0" height. Note – to adjust the height with precision,
press the s and t keys several times consecutively (at each pulse the awning/shutter moves a few millimetres).
05. n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
01
5
sec.
04
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.6.2 - To adjust the LOWER limit switch ("1")
Before starting the procedure, bring the awning/shutter to the midpoint of its stroke (note – if a limit switch has already been memorised, the motor will make 1
movement).
01. n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. n key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
03.
t key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
04. Adjustment of the position
press the s and t keys several times consecutively (at each pulse the awning, or shutter, moves a few millimetres).
05. n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
5 – English
ON
2
02
2
05
"0"
5
sec.
t (or s) key pressed until the awning/shutter reaches the desired "1" height. Note – to adjust the height with precision,
PROCEDURES
02
3
5
sec.
using this same procedure. •
4
5
sec.
END
3
END
s and t keys of the transmitter. This combination
03
2
5
sec.
.