Nice Era Fit Series Instructions And Warnings For Installation And Use page 7

01
5
sec.
04
Notes – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
mand the Lowering motion. The awning/shutter will move within the limits constituted by the two limit switch heights.
5.7 - Semiautomatic programming of the limit switches
same procedure also applies when the retainer is in the Lower limit switch "1".
• The first limit switch to be adjusted must be the one with the retainer against the structure: the procedure below is an example of programming
. •
2 movements are performed if at least one transmitter and the limit switch heights are not in the memory.
Before starting the procedure, bring the awning to the midpoint of its stroke (note – if no limit switches are present, the motor makes 2 movements).
01. Run the UP command by keeping the s (or t) key pressed and wait for the awning to stop automatically as result of the impact against the box. Upon comple-
tion, release the key.
02. Run the Down(*) command by keeping the s (or t) key pressed and release the key when the awning is next to your chosen lower limit switch "1".
03. n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
04.
n key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
05. t key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
06. Fine adjustment of position: Press the t and s keys until the awning reaches the "1" height you want (at each pulse the awning moves a few millimetres).
07. n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
(*) – If a limit switch has already been memorised, the motor will make 1 movement at the start of he manoeuvre.
01
03
2
5
sec.
06
fine adjustment fine regulation
Notes – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
.
switch "0"), while during the Lowering manoeuvre the awning will stop at the lower limit switch ("1") estabilished by the installer.
02
2
05
"1"
5
sec.
. •
"0"
04
5
sec.
07
"1"
5
sec.
. •
4
5
sec.
3
END
s key will command the Raising motion and the key t key will com-
using this same procedure. •
02
05
4
3
END
s key will command the Raise manoeuvre and the t key will com-
03
2
5
sec.
"1"
2
5
sec.
English – 6