Program Edit Mode; Line Edit; Screen Edit - Sanyo MBC-550 Series User Manual

Program Edit Mode
The program edit mode means to enter, to edit, and to
store a Sanyo Basic source progam into the memory.
(1) Line edit
When a line number and a statement are entered, the
system stores them into the memory as a source program.
Line numbers can be automatically generated using the
AUTO instruction. A renumbering operation can be
performed to assign numbers to an entire source program
using the RENUM instruction. "A line number and a
statement" can be repeated and a series of program is
stored to the memory sequentially. Then this program
can be executed using the RUN instruction.
(2) Screen edit
key ( 0 )
When the cursor
execution mode, the control becomes the screen edit
mode.
is entered in the direct
The displayed program can be partially modified. Using
the screen edit mode, the cursor can be freely moved to
the place where the user wants to make correction so
that he can insert and delete. After modifications,
the cursor returns to its original prompt mark position
and the system enters Sanyo Basic mode if the BREAK key
is entered. The program is modified a appeared on the
screen and stored into the memory when the BREAK key is
entered.
3-5