Sanyo MBC-550 Series User Manual page 36

Press the RETURN key if you do not want to change the
time shown,
form:
A new time may be entered in the following
hh is a one or two digit number from 0-23
and represents the hour.
mm is a one or two digit number from 0-59
and represents the minutes.
You do not have to enter the seconds ss or the
hundredths of seconds
cc.
The hour and minute entries must be separated by colons
:. Depress the RETURN key after you have entered the
time.
The system uses the time entered as the new time if
entered correctly.
correctly, the following message will be displayed:
If you do not enter the time
Invalid time
Enter new time:
You may enter the correct form for the time or depress
the RETURN key to use the time displayed previously.
You are now at command level (DOS) and will see the
prompt A:
You may obtain a listing of the files on your disk by
entering DIR followed by a depression of the RETURN
key. By entering the filenames with a .COM at the end
of them, you may access
enter the appropriate filename of any software availa­
ble to you on your disk.
those system commands, or
THE TIMER OF THE COMPUTER DOES NOT ALWAYS NOTE:
INDICATE THE ACCURATE TIME AS THE CLOCK OF THE COMPUTER
STOPS WHILE THE FLOPPY DISK DRIVE IS BEING ACCESSED.
1-25