Micromeritics SediGraph III 5120 Installation Instructions And Checklist page 14

Attaching Tubes and Cables
2. Connect an RS232 cable to the connector on the rear panel of the analyzer and to the
computer.
3. Connect the power cable to the connector on the rear panel of the analyzer and to a
power source.
4. Slide out the drip tray under the lower panel of the analyzer.
5. Insert the air filter in the slot provided at the rear of the tray.
6. Close the drip tray.
7. Open the analysis compartment door and locate the level indicator.
10
SediGraph III 5120 Installation
To computer
To power
source
Air filter
Drip tray
Mar 2010