Sun Microsystems Ultra 60 Product Notes page 20

Hide thumbs Also See for Ultra 60:

a. Feed the DC switch assembly power cable through the front of the front

b. Using a small ﬂat-blade screwdriver, press the detent tab on one side of the

c. Repeat Step b for the other side of the DC switch assembly.

d. Continue pressing the detent tab on alternate sides and pushing the DC

2. Replace the front panel (Figure 1–11):

a. Replace the nameplate onto the front panel, ensuring that the light pipe

b. Feed the DC switch assembly power cable through the chassis front (Figure

c. Position the front panel onto the chassis. Using a number 2 Phillips-head

d. Replace the front panel bezel (not illustrated).

3. Route the DC power cable along the chassis front and side. Secure the power

cable in place using the cable routing clips (Figure 1–10).

4. Connect the DC switch assembly power connector to motherboard connector

J3504 (Figure 1–10).

5. Replace the SCSI drive bay (Figure 1–9):

Caution -

drive bay area in the chassis.

Note -

a. Slide the SCSI drive bay into the chassis.

Sun Ultra 60 Product Note ♦ June 2000, Revision A

panel.

DC switch assembly while pushing the switch into the front panel from the

front.

switch assembly into the front panel until the DC switch assembly locks

into the front panel housing.

tabs are oriented with the nameplate cutouts.

1–10).

screwdriver, replace the four screws securing the front panel to the chassis.

Prior to replacing the SCSI drive bay, ensure that all cables are clear of the

Hooks at the drive bay base must lock into the bottom slots of the chassis.

Table of Contents