Brother KE100 Motor Drive User Manual page 9

©
For the KH-830, KH-835 and KH-836
The JOINT ASSEMBLING KIT is additionally required and this is an OPTIONAL PARTS.
OJ
Remove two screws to take off the carriage handle.
(This handle can not be attached to the joint.)
!.2J
Insert the collar to the hole @ from out side.
~ Place the joint with collar in between the handle setting bases.
@]
Insert the screw into the collar and screw it. If you push down the joint, it is easy to
insert the screw.
[Q]
Set the fastening plate to the screw from inside, then screw up tightly.
[Q]
Place the rubber block under the joint.
Fastening plate
Handle setting base
@
For the KH-120 and KH-710
The EXTENSION PLATE and JOINT ASSEMBLING KIT are additionally requiered and
these sets are OPTIONAL PARTS.
OJ
Remove two screws to take off the carriage handle.
(This handle can not be attached to the joint.)
!.2J
Put the extension plate to the reverse side of the joint, then fasten it with two screws by
using lower two holes.
~ Insert the collar to the hole @ from out side.
@]
Place the joint with collar in between the handle setting bases.
[Q]
Insert the screw into the collar and screw it. If you push down the joint, it is easy to
insert the screw.
[Q]
Set the fastening plate to the screw from inside, then screw up tightly. (The rubber
blocks are not used for these models.)
-8-