Section 3 - Symbols; Section 4 - Installation; Lifting And Transport; Unpacking - NUVE NF48 User Manual


Tubes which are used in the centrifuge should not be deformed by the effect of the
centrifuge force.

Use glass tubes to balance, if glass tubes are used. Use plastics tubes to balance, if
plastics tubes are used.

Do not start the device unless tubes are in balance.

Imbalance loading may cause mixing the samples, broken tubes, and damages on the
rotor and motor shaft.
If mentioned warnings are not considered, nüve will not be responsible
from their results.
SECTION 3 – SYMBOLS
Symbol in the operating instructions: Attention, general hazard area.
This symbol refers to safety relevant warnings and indicates possibly
dangerous situations. The non-adherence to these warnings can lead to
material damage and injury to personal.
Symbol in the operating instructions: This symbol refers to important
circumstances.
SECTION 4 – INSTALLATION
4.1.

LIFTING AND TRANSPORT

Because of the heavy weight of the centrifuge, all lifting and transport must be carried out
using proper handling equipment. The centrifuge should be lifted from underneath and never
be turned over.
4.2.

UNPACKING

Remove the packing cardboard box and the second nylon packing around the centrifuge.
The below written are provided with the instrument, please check them;

1 ea. User's manual

1 ea. Warranty certification

1 ea. Power cable

1 ea. Manual lid opening tool
4.3.

POSITIONING


Check that no damage has occurred during transport.

Check that the positioning is suitable for users.

Lift the centrifuge (use proper handling equipment if necessary) underneath and carry it
to its place. Check that the centrifuge is stable on its four pads.

The bench-top must be rigid enough to support the weight and vibrations.

Leave 30 cm. free space on the every side of the centrifuge.

Open the lid by using unlocking tool and check no substances left in the bowl.

Make sure that the centrifuge does not occupy the utilization space of nearby
equipment or do damage to them.

The user should be able to follow the centrifuge during the operation.
7