Connecting Power Supply; Fastening The Cable - Christie LW502 Setup Manual

Connecting power supply

1.
Put the connector of the power
cord into the AC (AC inlet) of
the projector.
2.
Firmly plug the power cord's plug into the outlet. In a
couple of seconds after the power supply connection,
the POWER indicator lights up in steady orange.
When the DIRECT POWER ON function activated, the connection of the power
supply make the projector turn on.
WARNING ►Use extra caution when connecting the power cord, as
incorrect or faulty connections may result in fire and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in fire, electric
shock or other accidents.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
NOTICE ►This projector is also designed for IT power systems with a
phase-to-phase voltage of 220 to 240 V.

Fastening the cable

Use the supplied cable tie to fasten the cable.
LW502/LWU502/LX602 Setup Guide
020-001101-03 Rev. 1 (02-2018)
Cable tie
AC
Power
cord
11