Cleaning And Replacing The Air Filter - Christie LW502 Setup Manual

Cleaning and replacing the air filter

Check and clean the air filter periodically. When the indicators or a message
prompts you to clean the air filter, replace the filter as soon as possible.
The extra air filter is attached to inner side of the filter cover. If one of the filters is
damaged or heavily soiled, replace whole filter set with a new one.
Request a filter set with the following type number from your dealer when
purchasing a new one.
Type number : 003-005853-01 (UX41161)
1.
Turn the projector off, and unplug the power
cord. Allow the projector to sufficiently cool
down.
2.
Use a vacuum cleaner on and around the
filter cover.
3.
Pick and pull up the filter cover knobs to
take it off.
4.
Press up slightly on the bottom side
knobs to unlock the bottom side of the
filter unit. Pull the center knob to take the
filter unit off.
5.
Use a vacuum cleaner to clean the filter
vent of the projector and the outer side of
the filter unit.
6.
Use a vacuum cleaner to clean the inner
side of each part of the filter unit to clean
them up. If the filters are damaged or
heavily soiled, replace them with the new
ones.
7.
Put the filter unit back in an upright state
into the projector.
8.
Put the filter cover back into the place.
(continued on next page)
LW502/LWU502/LX602 Setup Guide
020-001101-03 Rev. 1 (02-2018)
2
3
Filter cover
knobs
4, 5
Filter unit
knobs
6
Filter cover
Filter unit
7
18