Install The Valve Harness - Raven SmarTrax Installation Manual

Install the Valve Harness

Start with the valve harness (P/N 115-4001-236) outside the cab on the left side.
1.
Access Area for Routing Valve Harness
FIGURE 7.
Route the 12-pin connector behind the cab to the right side of the machine.
2.
Cab Access Panel
FIGURE 8.
Route the 12-pin connector into the cab through the access panel in the back-right corner of the cab.
3.
Note:
It may be necessary to cut a hole in the access panel to achieve cable routing.
Open the fuse panel cover inside the cab.
4.
Route the 12-pin connector forward and connect it to the mating connector on the node harness (P/N 115-
5.
4001-235).
P/N 016-5030-047 Rev. B
Cab Component Installation
19