Raven SmarTrax Installation Manual page 18

Chapter 3
Large Muffler Clamp Installed
FIGURE 10.
Remove the nuts and clamp from the 3" muffler clamp (P/N 435-3003-063) and install the U-bolt around the
9.
base-end of the steering cylinder shaft with the U-bolt ends pointing up.
Install the clamp on the ends of the U-bolt and secure it using the clamp's two nuts.
10.
WAS Installed on Base-End of the Steering Cylinder
FIGURE 11.
Insert the legs of the installed U-bolt muffler clamp through the holes in the base-end WAS mounting
11.
bracket (P/N 107-0172-300) so that the flange of the bracket is toward the end of the steering cylinder and
secure the bracket using 0.344" x 0.688" OD x 0.065" flat washers (P/N 313-2300-012) and two 5/16"-18
nylon insert lock nuts (P/N 312-4000-059).
Insert the stud on the base-end of the WAS (the end with the cable connection) through the hole in the
12.
base-end WAS mounting bracket and secure it using one M10 x 1.5 lock nut (P/N 312-4000-208).
Tighten all nuts used to install the WAS.
13.
Route the cable from the base-end of the WAS along the left side of the machine's frame, routing it so that
14.
the cable is not near moving parts or heat sources. Secure with plastic cable ties as necessary.
14 CLAAS Lexion 700 Series - Steering Ready Combine SmarTrax™ Installation Manual