Unit Installation - ADTRAN NetVanta 7000 Series Hardware Installation Manual

Unit Installation

5. UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics, such as mounting
options, supplying power to the unit, and installing option cards. These instructions are presented as follows:
• Mounting Options on page 35
• Supplying Power to the Unit on page 37
• Installing Network Interface and Voice Interface Modules on page 37
• Installing a CompactFlash Card on page 39
For information on configuring a specific application, refer to the configuration guides provided on the
ADTRAN's Support Forum
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
• The NetVanta 7000 Series is intended to be installed, maintained, and serviced by
qualified service personnel only and should be installed in a restricted access location
as described in UL/IEC 60950-1.
• Ethernet cables are intended for intrabuilding use only. Connecting an ADTRAN unit
directly to Ethernet cables that run outside the building in which the unit is housed will
void the user's warranty and could create a fire or shock hazard. To connect an
ADTRAN unit to Ethernet cables that run outside the building, ADTRAN's Ethernet
Port Protection Device (EPPD) (P/N 1700502G1) must be connected between the unit
and the outside plant cable. Use of any Ethernet protector other than ADTRAN's for this
purpose will void the user's warranty.
• PoE cables are intended for intrabuilding use only. Connecting an ADTRAN PoE unit
directly to PoE cables that run outside the building in which the unit is housed will void
the user's warranty and could create a fire or shock hazard.
• For outdoor PoE applications, ensure any PoE injector used is approved and rated for
outdoor/exposed wiring applications. Use of a PoE injector that is not rated for
outdoor/exposed wiring applications will void the user's warranty and could create a
fire or shock hazard.
Electronic modules can be damaged by static electrical discharge. Before handling
modules, put on an antistatic discharge wrist strap to prevent damage to electrical
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
34
or the AOS Command Reference Guide.
Copyright © 2014 ADTRAN, Inc.
NetVanta 7000 Series Hardware Installation Guide
61200796L1-34L