Stanley FatMax TruLaser TLM 300 User Manual page 18

User Manual
Version 1.0
English
Congratulations on your purchase of a Stanley
TLM 300.
The safety instructions can be
found in a separate booklet, which
accompanies this user manual. The
safety instructions along with the
user manual should be read carefully before initial
operation.
Helpful Hint: The first and last page including the
pictures should be folded out and left open, whilst
reading through the manual. Letters and numbers in
braces {} refer to the illustrations.
Content
Start-up
................................................................ 1
Menu functions
................................................... 3
Operation
............................................................. 4
Measuring
............................................................ 5
Functions
............................................................. 6
Appendix
.............................................................. 9
Stanley TLM 300 1.0.0 gb
Start-up
Inserting / replacing Batteries
See figure {B} - Open the positioning bracket.
Remove the locking clip and slide the endpiece down.
Slide the red locking mechanism to the side and open
the battery compartement. Insert new or replace
used batteries. Close battery cover, reinsert the
endpiece and fix locking clip.
The battery symbol {C, 20} appears permanently
blinking in the display when the battery voltage is too
low. The batteries should be replaced as soon as
possible.
• Pay attention to correct polarity.
• Use alkaline batteries.
• Batteries should be removed if the device will not
be used for a long time (danger of corrosion).
When changing the batteries the settings and stack
content remain unchanged.
1
D
GB
F
I
E
P
NL
DK
S
N
FIN
J
CN
ROK
PL
HR
H
RUS
CZ
Start-up
GR