Table of Contents
Advertisement
11. After you have recovered your onboard BIOS, you can choose to remove or not
remove the ABS Card from the mainboard.
If you do choose to remove the ABS Card from the mainboard, make sure that the system
is powered off before you remove the card. After you remove the ABS card you must
replace the two jumper caps on the ABS header back to the default positions (pins 1-2 and
pins 3-4 are both closed as shown).
If you choose not remove the ABS Card from the mainboard, make sure that the jumper
caps on the ABS_JP1 header located on the ABS Card to the
order to reduce the damage opportunity of the rescue BIOS in ABS Card and on the other
hand to extend the usage life of the ABS Card.
Attention
If both your onboard BIOS and rescue BIOS are damaged
unfortunately, the ABS Card will fail the feature of providing BIOS
backup. Therefore, it is recommended that recover the onboard BIOS in
advance, and take the ABS Card as emergency happen.
("Closed" means putting a jumper cap
onto two adjacent header pins.)
47
Mainboard PX915P-2V
ABS
"Onboard
BIOS" as below, in
Advertisement
Table of Contents
