Albatron PX915P-2V User Manual page 34

Onboard Serial Port 1
Select an address and corresponding interrupt for the first/ second serial port.
Options: Disabled,3F8/IRQ4 (Default for port1),2F8/IRQ3,3E8/IRQ4,2E8/IRQ3,Auto
UART Mode Select
This option allows you to select the Infra Red (IR) standard to be used.
Options: Disabled (Default),IrDA
RxD, TxD Active
This option determines the RxD and TxD frequencies. This option is configurable only if
"UART Mode Select" is set to "IrDA".
Options: Hi / Lo (Default),Hi / Hi,Lo / Hi,Lo / Lo
IR Transmission Delay
This option allows you to enable/disable IR transmission delay. This option is configurable
only if "UART Mode Select" is set to "IrDA".
Options: Enabled (Default),Disabled
UR2 Duplex Mode
Select the transmission mode used by the IR interface. Full-duplex mode permits
simultaneous bi-directional transmission. Half-duplex mode permits transmission in only
one direction at a time. This option is configurable only if "UART Mode Select" is set to
"IrDA". Options: Half (Default),Full
Use IR Pins
Consult your IR peripheral documentation to select the correct setting of the TxD and RxD
signals. This option is configurable only if "UART Mode Select" is set to "IrDA".
Options: IR-Rx2Tx2 (Default),RxD2,TxD2
Onboard Parallel Port
Select an address and corresponding interrupt for the onboard parallel port.
Options: 378/IRQ7 (Default),278/IRQ5,3BC/IRQ7,Disabled
Parallel Port Mode
This option allows you to select a parallel port mode for the onboard parallel port.
Options:
ECP (Default) Extended Capabilities Port.
EPP Enhanced Parallel Port.
SPP Standard Printer Port.
ECP+EPP ECP & EPP mode.
Normal
Mainboard PX915P-2V
30