Table of Contents
Advertisement
8. The initial AWARD BIOS FLASH screen (shown below-left) will appear and prompt you with
the message, "Do you want to save BIOS?" Type "N" (Note: Typing "Y" is only used when
saving the BIOS from the onboard BIOS to the floppy disk).
The next screen (shown above-right) will display a message "Press 'Y' to Program or 'N' to
Exit". Then type 'Y' to begin the onboard BIOS flash procedure.
9. The flashing procedure will take several minutes and will show its progress on the
screen. After the flash BIOS procedures have completed, press 'F1' to reboot the system.
Attention
While processing the flash BIOS procedures, DO NOT power off or
restart your system. Otherwise, it may damage the onboard BIOS.
Type N
When the flash process is complete, press 'F1'
45
Mainboard PX915P-2V
Type Y
Advertisement
Table of Contents
