Electrical Section - Elba EH 733 WH Manual

IMPORTANT:
Installation has to be carried out
according to the instructions provid-
ed by the manufacturer.
Incorrect installation might cause
harm and damage to people, animals
or objects, for which the manufactur-
er accepts no responsibility.
DETAILS
Connection to the electric power
supply must be carried out by a
qualified technician and following the
appropriate safety regulations;
Before carrying out the connection to
the power supply, the voltage rating of
the appliance (stamped on the
appliance identification plate) must be
checked for correspondence to the
available mains supply voltage, and
the mains electric wiring should be
capable of handling the hob's power
rating (also
identification plate);
The power point must be connected to
a suitable earth wiring, in conformity
to current safety regulations.
If the appliance is supplied without
plug, fit a standard plug which is
suitable for the power consumed by
the appliance.
The colours of the wires in the hob
power cable may not correspond with
the colours marked on the terminals of
your electrical plug. The plug should
in any case be wired as follows:
– connect the green/yellow wire to the
terminal marked with the letter E or
the earth symbol or coloured
green/yellow;
– connect the blue wire to the
terminal marked with the letter N or
coloured black;
– connect the brown wire to the
terminal marked with the letter L or
coloured red.
22

ELECTRICAL SECTION

indicated on the
It is possible to connect the appliance
directly to the mains supply by means
of a heavy duty switch with 3 mm
minimum distance between the
contacts.
The power supply cord must not touch
against any hot surfaces and must be
placed so that its temperature does
not exceed 75°C at any point along its
length.
After having installed the appliance,
the power switch or power plug must
always be in a accessible position.
N.B. For connections to the mains
power supply, never use adapters,
reductions or multiple power points
as these may overheat and catch fire.
In the event that installation should
require modifications to the mains supply
wiring system or if the power plug is not
suitable for the type of power point
available, it is recommended that a
qualified technician be called to carry out
substitution.
The technician will also have to verify
that the cross-section of the electric
cables on the power point match the
appliance's power rating.