Elba P60 Series Instruction For The Use - Installation Advice page 11

Models fitted with electric light-
er incorporated into the burner
knobs
The electric ignition is incorporated in
the knobs ( symbol beside flame
max. heat/max. gas flow fig. 2.1b).
To light one of the gas burners, push in
and turn the relative knob to the maxi-
mum aperture position (large flame sym-
bol) and hold the knob in until the flame
has been lit.
The sparks produced by the lighter situ-
ated inside the relative burner will light
the flame.
Adjust the gas valve to the desired posi-
tion.
N.B. If your local gas supply makes it
difficult to light the burner with the knob
set to maximum, set the knob to mini-
mum and repeat the operation.
N.B. When the cooker top is not being used, set the gas knobs to their closed posi-
tions and also close the cock valve on the gas bottle or the main gas supply line.
Fig. 2.2
LIGHTING GAS BURNERS
FITTED WITH SAFETY VALVE
DEVICE
In order to light the burner, you must:
) -
1 – Turn the knob in an anti-clockwise
direction up to the maximum aper-
ture, push in and hold the knob;
In models with the gas lighter incor-
porated in the knob, this will light
the gas. If there is no mains electri-
cal supply, bring a lighted match
close to the burner.
2 – For models with push-button light-
ing only: push the gas-lighter but-
ton.
3 – Wait about ten seconds after the
gaslights before releasing the knob
(starting time for the valve).
4 – Adjust the gas valve to the desired
position.
If the burner flame should go out for
some reason, the safety valve will auto-
matically stop the gas flow.
To re-light the burner, return the knob to
the closed
1 minute and then repeat the lighting
procedure.
Fig. 2.3
(fig. 2.1b)
position, wait for at least
●
11