Features - ITW SIMCO ION IQ Power Installation And Operating Instructions Manual

IQ Power BPS Power Supplies use 8-conductor modular cable and RJ-45 connectors
for connection to the IQ Power system. They are typically supplied with 7 foot cable
assemblies but longer lengths are available by calling Simco-Ion customer service
(800) 203-3419 (refer to Section 8, Parts and Accessories).
Anybus® CompactCom is a registered trademark of HMS Industrial Networks.

Features

• Three types of IQ Power static neutralizing bars are available to suit the
specific application.
• Static bar disconnect plug pre-installed on static bar cable for quick and
easy installation. Plug also identifies bar type to power supply automating
power supply set-up.
• Single momentary push-button calibration simplifies set-up.
• Ionization emitter points current limited to enhance operator safety.
• Ionization emitter points of special alloy to extend operating life of emitter
points.
• Continuous "T" slot at back of static bar and mounting brackets for easy
and flexible installation.
• Bar graph display on power supply indicates ionizing performance of
system.
• Indicators on power supply display status of neutralizing system, power,
service required and detection of system faults.
• Relay contact output "echoes" indicators on power supply for remote
sensing and alarm.
• Optional control station that provides power and a communication hub for
IQ Power static neutralizing systems and an available fieldbus interface.
• Optional static sensor bar for gathering web charge data (used in CLFB
mode).
IQ Power BPS
3
5201249 Rev. D