Installation - Tripp Lite B064-000-STN Owner's Manual

2. Setup

2.2 Installation

The B064-000-STN HDMI KVM over IP Remote User Console Station supports hot-plugging, which allows you to connect,
disconnect, add or remove components without having to shut down the unit. If it becomes necessary to power off the Remote
User Console Station, use the shutdown function, disconnect the power adapter and wait 30 seconds before reconnecting it.
Note: The numbers shown in Figure 5 correspond to the installation steps below.
1. Connect your USB keyboard and USB mouse, as well as any speakers or microphone.
2. With a user-supplied HDMI cable, connect an HDMI display to the HDMI port on the unit.
3. Plug an Ethernet cable from the network into the LAN port.
4. (Optional) Plug USB flash drives or devices into the peripheral USB ports on the front of the unit.
5. (Optional) To cascade an additional B064-000-STN unit, plug one end of a user-supplied Cat5e/6 Ethernet cable into the
port labeled CASCADE on the first stage unit, then plug the other end of the Ethernet cable into the LAN port of a second
stage B064-000-STN unit. The added unit will gain the first stage unit's internet connection but configuration and control
of each unit is separate.
Note: DO NOT connect the cascade port to a network switch or it will cause a switching loop.
6. (Optional) The unit can be grounded by attaching a grounding wire to the Grounding Terminal, then to a suitable, earth-
grounded object. Note: Grounding wire is not included.
7. Connect the included external power supply to the power jack on the unit.
4
6
7
3
Figure 5: Installation
1
2
8
5