Tripp Lite B064-000-STN Owner's Manual page 24

5. System Configuration
2. Enter the required information in the appropriate fields. A description of the required user fields is given in the following
table:
Field
Username
Password
Confirm Password
Description
Role
Status
If you choose Groups in the left-hand side menu, click Add Group to bring up the following page:
A description of the required fields is given in the following table:
Field
Group Name
Description
3. You can assign the new user to a group by selecting the Groups tab (refer to section 5.1.2.2 Using Group Configuration
Page). You can also assign the user's port access rights by selecting the Devices tab (refer to section 5.1.3.1 Using
Device Configuration Page).
Note: Optionally, you can skip this step now to add more users and create groups, and come back to it later.
4. When your selections have been made, click Save.
5. When the Operation Succeeded message appears, click OK.
Description
1 to 32 characters are allowed depending on the Account Policy settings (refer to section
5.2.4.2 Account Policy).
0 to 32 characters are allowed depending on the Account Policy settings (refer to section
5.2.4.2 Account Policy).
Reenter the password to ensure there are no mistakes. The two entries must match.
Additional information about the user you may wish to include.
There are two categories: Administrator and User. There is no limit on the number of accounts
that can be created in each category.
The Administrator is responsible for the overall installation configuration and maintenance, user
management and device assignments.
Each user assigned to administrator role will have privileges to add KVM over IP switches by
default.
Refer to section 5.1.2.1 Using User Configuration Page.
Status allows you to control the user's account and access to the installation, as follows:
• Disable Account lets you suspend a user's account without actually deleting it, so that it can
be easily reinstated in the future.
• To require a user to change their password at the next log on, select "User must change
password at next logon". This can be used by the administrator to give the user a temporary
password to log in for the first time, and then let the user set their password of choice for
future logins.
• To make a password permanent, so that the user cannot change it to something else, select
"User cannot change password".
Description
Up to 32 characters are allowed.
Additional information about the user group you wish to include, to a maximum of 45
characters.
24