Setup; Mounting Instructions - Tripp Lite B064-000-STN Owner's Manual

2. Setup

2.1 Mounting Instructions

The B064-000-STN can be rack mounted or wall mounted. The following section will guide you through the proper steps.
Rack Mounting
The KVM over IP Console Station is designed to be mounted at the rear of a rack, where it occupies 0U to save space.
1. Remove two bottom screws on the unit. Use the screws to secure the mounting plate to the bottom of the unit as shown in
Figure 1.
2. Screw the mounting plate to any convenient location in the rear of the rack.
Note: These screws are user-supplied. M5 x 12 Phillips type I cross screws are recommended.
M3 x L5 (Countersunk Head)
Figure 1: Secure Mounting Plate to Unit
Figure 2: Secure Unit to the Rack
6