Tripp Lite B064-000-STN Owner's Manual page 59

6. Toolbar Interface
2. Click the + symbol and select the media source.
3. If your device only supports full speed USB, check the Disable High Speed USB Operation Mode checkbox.
4. To add additional media sources, click the + symbol and select the source as many times as you require. Up to two virtual
media choices can be mounted. The top three in the list are the ones that are selected. Virtual Media and Smart Card
readers can be mounted at the same time. To rearrange the selection order, highlight the device you want to move, then
click the Up or Down Arrow button to promote or demote it in the list.
5. Read refers to the redirected device being able to send data to the remote server; Write refers to the redirected device
being able to have data from the remote server written to it. For the redirected device to be writable as well as readable,
click to put a check in the Enable Write checkbox.
Note: If a redirected device cannot be written to, it appears in gray.
6. To remove an entry from the list, select it and click the trash can icon.
7. After you have made your media source selections, click "Mount". The dialog box closes. The virtual media devices that you
have selected are redirected to the remote server, where they show up as drives on the remote server's file system.
Once mounted, you can treat the virtual media as if they really exist on the remote server – drag and drop files to/from them,
open files on the remote server for editing and save them to the redirected media, etc.
8. To end the redirection, bring up the Control Panel and click on the Virtual Media icon. All mounted devices are automatically
unmounted.
59