Firmware Upgrade Recovery; Backup/Restore - Tripp Lite B064-000-STN Owner's Manual

5. System Configuration
5. Navigate to the directory that the new firmware file is in, click to select the file and click "Open".
6. Click Upgrade Main Firmware to start the upgrade procedure.
• If you enabled Check Main Firmware Version, the current firmware level is compared with that of the upgrade file. If the
current version is equal to or higher than the upgrade version, a popup message appears to inform you of the situation and
stops the upgrade procedure.
• If you didn't enable Check Main Firmware Version, the upgrade file is installed without checking its level.
• Upgrade progress information is shown in a Progress bar.
• Once the upgrade completes successfully, the console station will restart.
7. Log in again and check if the firmware version is the newest one.
Note: To recover from a "failed upgrade" situation, refer to Firmware Upgrade Recovery below.

5.3.2 Firmware Upgrade Recovery

Should the console station's main firmware upgrade procedure fail and the console station becomes unusable, follow the
firmware upgrade recovery procedure below to recover the console station to its original firmware version:
1. Power off the console station by unplugging the power adapter.
2. Press and hold the reset switch using a pointed object.
3. While holding in the reset switch, power up the console station by replugging the power adapter.
This reverts the console station to use the original factory installed firmware. Try upgrading the main firmware again when the
console station is operational.

5.3.3 Backup/Restore

Backup/Restore gives you the ability to back up the console station's configuration and user profile information.
Click "Backup/Restore" under "Maintenance" in the left-hand menu to bring up the information page.
38