Safety Measures - Heinner HSF-500S Instruction Manual

www.heinner.com 500W, 50/60 Hz, 220-240V
IV. SAFETY MEASURES
1. This machine is unavailable for the weakness, unresponsive or psychopathic person
(including children), unless under the direction or help from the person who have the
responsibility security. Children should be overseen, so it can be testified that they are
not playing with it.
2. Before using, put this machine on a stable and even table board; operate according
to the above methods.
3. Before juicing, first confirm juicing net and rotor clutched in position, and no hard
contact between juicing net cutter and transparent cover. Put the transparent cover on,
fasten tight the handle, then turn on the machine.
4. Before being used, the motor works in running-in phase, there may be slight peculiar
smell and spark, this is normal, after the motor works for some period, the above
phenomenon will disappear.
5. During juicing, make sure there is not too full juice and residue in the middle seat
and residue cup, if too full, please cut off power supply, clean up, and then use again.
6. During using, do not open the cup cover. In case power supply is on, do not put hand
or any ware into the mixing cup or feed port, otherwise, harmful accident may occur or
this machine may be damaged.
7.In order to prolong service life of this machine, over-temperature protective device is
mounted in the motor. If the motor works for a long time or overloaded, when over
warning temperature, power supply will automatically cut off. After the motor stops,
pull out plug of power supply, wait for the motor to cool (about for 30 min), use again.
8. Please make sure to put down the spout before do the extraction, only after the
operation consumers can put up the spout, then it can avoid the rest of source drop
down onto the table.
9. During operating, please do not leave, never let children operate this machine.
10. After operation, do not pour the food out until pul out the plug of power supply.
11. Cutters are very sharp, in order to avoid danger, when cleaning a cutter, please put
the cutter under water tap for washing, do not wash it with hand.
12. This machine must not be used for others beyond regulated purposes.
13. In case of damaged power supply cord, in order to avoid danger, replacement must
be performed by the manufacturer or its service department or similar professional
persons.
3