Freescale Semiconductor 56F8000E Installation Manual

Freescale Semiconductor
56F8000E Motor Control Daughter Card Kit Installation Guide
Thank you for choosing this Freescale Development Tools product. This document
provides instructions on how to set up the Freescale Motor Control Daughter Card
with the 56F8013 Demonstration Board. If you have any questions regarding the
hardware kit or software development tools, please contact the Technical
Information Center:
www.freescale.com/support

Kit Contents

Your 56F8000E Motor Control Daughter Card kit includes:
Hardware
• 56F8000E Motor Control Daughter Card (APMOTOR56F8000E)
Documentation
• 56F8000E Motor Control Daughter Card Kit Installation Guide (this
document)
• Warranty Registration card
1

Install the 56F8000E Motor Control Daughter Card and the 56F8013 Demonstration Board

1. Remove all power connections from the demo board and the daughter card.
2. Connect the 56F8000E Motor Control Daughter Card to the 56F8013 Demonstration Board via the 40-pin expansion connector.
• Align pin 1 from the P1 connector on the 56F8000E Motor Control Daughter Card with pin 1 of the expansion connector on the
56F8013 Demonstration Board as shown.
© Freescale Semiconductor, Inc., 2005, 2006. All rights reserved.
APMOTOR56F8000KIG
Rev. 2, 06/2006

Welcome!

Apply power here

System Requirements

• 56F8013 Demonstration Board
(DEMO56F8013 or DEMO56F8013-E)
• CodeWarrior Development tools with
TM
Processor Expert
Help
To obtain assistance for the 56F8000E
Motor Control Daughter Card, please
contact the Technical Information Center:
www.freescale.com/support