FIGURE 13. Seat Switch Harness Connections
2. Locate and disconnect the machine's seat switch harness connections.
3. Connect the SEAT SWITCH harness connections of the HDU switch harness cable between the machine's seat
switch connections.
4. Connect the ENGAGE connector of the HDU switch harness cable to the machine's mating X-708 REMOTE
ENGAGE SWITCH connector, located behind the vent access cover.
FIGURE 14. Master Switch Installation Location
5. Locate an unused switch port of the machine's control console.
6. Use a flat-head screwdriver to gently remove the cover of the unused switch port.
7. Route the MASTER connector on the HDU switch harness cable up the right corner post of the cab and into the
control console casing.
8. Pull the MASTER connector through the switch port opening.
016-5032-109 Rev. D
CAB COMPONENT INSTALLATION
29