Kubota R430 Operator's Manual page 17

Wheel loader
Table of Contents

Advertisement

(1) LST pump
(2) Parking brake
(3) Adjust bolt
• Do not install any tires on the rims yourself because
serious or fatal accidents could happen. Have the
tires mounted by your KUBOTA dealer.
• Use a face mask or eye protection to protect the
eyes and respiratory system against dust and other
foreign particles.
R430
(4) M8 nut
(5) Machine recovery pin
SAFE OPERATION
• Refuse such as old oil, fuel, hydraulic fluid, coolant,
and batteries comes under the category of toxic
waste and can be a hazard to the environment,
people, and animals.
• Undertake
disposal
according to legally prescribed pollution control and
safety regulations.
• If you ask questions about the correct disposal or
storage of refuse and toxic waste, contact your
KUBOTA dealer or a local waste management
contractor.
• Do not open high-pressure fuel system. High-
pressure fluid remaining in fuel lines can cause
serious injury. Do not disconnect nor repair fuel
lines, sensors, or any other components between
the high-pressure fuel pump and injectors on
engines with high-pressure common rail fuel
system.
• To avoid hazardous high voltage, turn the key
switch to the off position if it is necessary to check
to repair the computer, harness, or connectors.
• Keep the wheel loader away from people, animals,
or structures which may be susceptible to harm or
damage from hot exhaust gases.
• Fire prevention
Wheel
loader
and
components that are at high temperatures under
normal operating conditions. The primary source of
high temperatures is the engine and exhaust
system.
The electrical system, if damaged or incorrectly
maintained, can be a source of arcing or sparks.
The following fire prevention guidelines will help to
keep your equipment up and running efficiently and
keep the risk of fire to a minimum.
– Blow off all accumulated debris near hot
engine-exhaust-components
turbocharger and exhaust manifold as well as
EGR tube, exhaust pipes, and muffler more
frequently when working in severe conditions.
– Clean out all accumulated flammable debris
such as leaves, straw, pine needles, branches,
bark, small wood chips, and any other
combustible materials from inside the machine
in
an
appropriate
way,
some
attachments
equip
such
as
13

Advertisement

Table of Contents
loading

Table of Contents