Rack-Mounted Installation - Compex SXP2226WM User Manual

Chapter 3 Hardware Installation
5.
6.
7.
8.
9.
3.1.2

Rack-Mounted installation

1.
2.
3.
4.
5.
6.
7.
NOTE
Please allow at least 4 inches of clearance on the front and back of the switch
for proper ventilation. This is especially important for enclosed rack
installation.
11
Using a RJ45 MDIX crossover cable, connect one end to the
management port of Compex SXP2226WM and the other end to the
PC as shown in Figure 3.1a.
Next, insert the power cord into the socket located at the back of
Compex SXP2226WM and power on the device.
Check that the POWER LED at the front panel of Compex
SXP2226WM has lighted up.
The unit is now ready for configuration.
Please refer to Chapter 4 for details.
Position one bracket to align with the holes on one side of Compex
SXP2226WM and secure it with the smaller bracket screws (1/8-inch
diameter). Then attach the other bracket to another side of it.
After attaching both mounting brackets, position the device in the rack
by lining up the holes in the brackets with the appropriate holes on the
rack. Secure it to the rack using the rack-mounting screws (5/16 inches
diameters) with a screwdriver.
Using a RJ45 MDIX crossover cable, connect one end to the
management port of Compex SXP2226WM and the other end to the
PC as shown in Figure 3.1a.
Next, insert the power cord to the socket located at the back of
Compex SXP2226WM and power on the device.
Check that the POWER LED at the front panel of Compex
SXP2226WM has lighted up.
The unit is now ready for configuration.
Please refer to Chapter 4 to continue the configuration process.