Compex SXP2226WM User Manual page 27

Chapter 5 Configure Compex SXP2226WM using Web Interface
Notice that the "Link state" option indicates 'Up'. This shows that the port is
connected to the network. It can either be in "Up" (Connected) or 'Down' (No
connection) state.
Speed/Duplex
To select the operation mode of the chosen port.
Port State
Enabling this function allows the chosen port to receive and forward the packets, and
learn the respective source MAC Addresses.
Broadcast Storm Control
Enabling this function allows you to control the reception of broadcasting packets.
When the number of broadcast packets in the input buffer of the chosen port is above
the threshold (this is the value that you have chosen in the Broadcast Storm Control
field), the new incoming broadcast packets will be discarded until the number is
below the threshold.
Flow Control
Reports the Flow Control setting of the port. Enabling the Flow Control function
allows Half and Full Duplex mode.
RX bandwidth
This option allows you to choose the bandwidth when receiving data.
TX bandwidth
This option allows you to choose the bandwidth when transmitting data.
NOTE
The port(s)* being activated with bandwidth control function must be forced
(set) to 10Mbps HD or 100Mbps HD to work correctly.
If bandwidth control is operated in Full-Duplex mode, the true transmit
bandwidth will be about 10-15 time less than the select value. This may varies
with different applications.
*Only applies to the 24 10/100Mbps ports.
Port #25 and #26 do not support bandwidth control (RX bandwidth and TX
bandwidth) function.
19