Changing Of Ip Address - Compex SXP2226WM User Manual

Chapter 5 Configure Compex SXP2226WM using Web Interface
5.5

Changing of IP Address

IP address configuration is for configuring IP address of the management board in the
switch. It is likely that several VLANs are on the single switch, and each VLAN can
be regarded as an independent network, so their network addresses may be different.
In order that each end-station connected to switch can access the management system,
multiple IP addresses are needed for the management board. The management board
of Compex SXP2226WM can assign multiple IP addresses to a maximum of 8.
You may set and save your addresses in the individual IP Index with different
addresses. This means that if your workstation is pre-configured as 192.168.100.200,
you may set your Compex SXP2226WM as 192.168.100.xxx at any of the IP INDEX.
Ensure that both your workstation and Compex SXP2226WM are in the same subnet.
The options for individual parameters are shown below:
IP INDEX
A number to identity the IP Configuration.
IP Address #
An Internet Protocol (IP) address contains a full 4 bytes (32 bits) of data and can be
subdivided into classes. The values of the leftmost four (4) bits of an address
determine its class. The '#' sign refers to the Index number chosen.
Subnet Mask#
Just like IP addresses, Subnet Masks contain four bytes (32 bits) and usually appear
in the same "dotted decimal" notation. By default, Class C Subnet Mask
255.255.255.0 is set. Users may configure the network with Class A (255.0.0.0) and
Class B (255.255.0.0) Subnet Mask as well. The '#' sign refers to the Index number
chosen.
28
Figure 5.5a Changing of IP Address