Tensioning Of The Discharge Conveyor - SaMASZ UNO 600 Operator's Manual

It is crucial to remember about periodic lubrication of flush grease nipples located in
bearings, support leg and levers controlling the distributor which will guarantee safe operating of
the machine.
8.7.
Discharge conveyor located on the front or the back of the machine is used to unload fodder.
To ensure it functions properly, its tension needs to be regulated after few hours of working. It also
needs to be regulated when it slides on the arbor. To do so, loosen the screws of arbor's bearings
tightened from the side of the strip (1,2,3,4) and tighten it by 5mm. If the belt is still too loose,
tighten it by 5mm again. It is crucial to tighten the screws on the bearing ofarbor tightening
discharge conveyor and check if the belt is working properly. Discharge conveyor cannot be too
tight because it may cause damage. It is important that it is tightened equally from both sides and is
not crooked.
Fig. 13. Tensioning discharge belt - 1,2,3,4 – Bearing screws of arbor tightening discharge conveyor;
5 – Loosenng discharge conveyor; 6 – Tightening discharge conveyor
Instruction manual
Fig. 12. Lubricating discharge indicator

TENSIONING OF THE DISCHARGE CONVEYOR

Fodder wagons OptiFEED
16