Cleaning; Lubricating - SaMASZ UNO 600 Operator's Manual

Fodder's quality depends on adequate sharpening of auger's blades. In order to keep
fodder's quality high, avoid overloading the tractor and the wagon during the work, increase its
longevity and reduce fuel consumption, check auger's blades sharpness once a month. Damaged
blades should be replaced as soon as possible. Blades on the auger are not subject to warranty.
WARNING!
SCREWS AND NUTS MUST BE TIGHTENED AFTER FEW HOURS
OF NEW MACHINE'S WORK. THIS PROCEDURE SHOULD BE
USED AFTER EACH REPAIR AND INTERIM REVIEWS – AT
LEAST ONCE A MONTH.
8.5.
Never use high pressure water to clean parts of weighing system. Remember to remove
remaining of the fodder containing grain seeds enriched with caustic soda that is located on the
external parts of the machine. After cleaning the machine with pressurized water, make sure that it
did not get to the oil.
8.6.
Make sure that the machine was properly lubricated before turning it on.
Lubricant type: High quality universal lubricant.
PTO should be lubricated once a week. Pay attention to PTO's profile sliding tubes. They
must be able to perform longitudinal moves, even at high torques. Failing to lubricate profile pipes
will result in great increase of axial force which in turn may damage the power take-off and other
transmission shafts.
Instruction manual
Tightening torques for nuts and bolts MA

CLEANING

LUBRICATING

Fodder wagons OptiFEED
14