Power Take Off; Connecting Electric Wires; Assembling The Cantilever Controlling The Distributor; Actions To Perform Before First Use - SaMASZ UNO 600 Operator's Manual

6.2.
It is recommended to use power take-off that came with the fodder wagon. If there is a need
to change its length, please follow the manufacturer's manual. It also refers to maintenance and
lubrication.
6.3.
Weight control system's electric cords as well as road lights and transportation lights need to
be connected to trailer's electrical output. It is important that the connector is in a good shape
because weight's control system requires voltage of minimum 11V.
WARNING!
MAINTAIN THE CONNECTOR IN A GOOD SHAPE.
6.4.
DISTRIBUTOR
Additional cantilever controlling the distributor needs to be installed in tractor's cabin. Make
sure that the cords are not clamped or bent in a sharp degree as it would increase friction and would
cause troubles controlling the switches.

7. ACTIONS TO PERFORM BEFORE FIRST USE

Before you start using the machine, please perform following actions:
1. Read the manual carefully.
2. Make sure that the fodder wagon is properly connected and is not damaged.
3. Check the manual for recommended value for power take-off revolutions and compare it
with tractor's capabilities. Rotational speed too high may be very dangerous.
Instruction manual

POWER TAKE OFF

Fig. 8. PTO shaft

CONNECTING ELECTRIC WIRES

ASSEMBLING THE CANTILEVER CONTROLLING THE
Fig. 9. Bracket for distributor control
Fodder wagons OptiFEED
11