Product Description - Axis 2n SingleTalk User Manual

1.1 Product Description

Basic Features
The SingleTalk ST
there is just one lift and no internal communication between the lift car and the
machine room/shaft bottom/lift car roof is needed (
more complex applications).
The ST is a Speakerphone in principle. This means that, built-in behind the lift
panel (wall surface), the
directional voice communication.
The ST can be connected directly to a PSTN line, being supplied from this line.
Thus, it requires no battery
local PBX line or a GSM gateway too (refer to the Associated products).
The ST cannot be misused to someone else's debit because it can dial the pre-
programmed numbers only.
On the top of it, the
needed either on purchase, or any time later.
Advantages of use
Basic messages even without the voice recording module
Messages of a variable length of 0 to 30 seconds – with the voice recording
module only
Checking Call once in 3 days
Digitally adjustable acoustic properties (remote setting)
Function indication – two LEDs compliant with applicable lift regulations
Phone-based programming and checking
Hang-up and busy line detection
Automatic repeated dialing of multiple numbers
Protection against unintentional or unneeded initiation (CANCEL)
Call control from the dispatching center
No need of power supply
Easy installation onto any panel
Approved for connection to the PSTN
2N TELEKOMUNIKACE a.s., www.2n.cz
( ) is intended primarily for lifts – especially in buildings, where
ST microphone and loudspeaker are used for bi--
and no maintenance
ST can be provided with various extending modules as
®
2N Lift8 is designed for
. It can be connected to any
5/82