Axis 2n SingleTalk User Manual page 68

Communicator for lifts
Hide thumbs Also See for 2n SingleTalk:
Table of Contents

Advertisement

Call Termination (Outgoing and Incoming Calls)
The busy or continuous tone*) is detected (for PBX call termination).
10 ringing tone*) periods are detected (for a change use parameter 954). This is
an innovation compared with the earlier model.
The maximum call length has elapsed – the
call is being terminated" message 10 seconds before the end; the call may be
prolonged.
vyprší nastavená maximální délka hovoru – 10 sekund před vypršením ST
přehraje hlášení „Pozor, končí hovor", hovor lze prodloužit.
The
or
The timeout has expired during programming, or upon message recording.
30 seconds after switch activation.
The same button is pressed during an outgoing call that was used for making
the call (this function is disabled in the lift version).
Note
The
ST
the tone has two frequency components as the case is in the UK and
USA (BTT) and in Canada. This new function requires no parameter. One
of the tone components must be 440 Hz
2N TELEKOMUNIKACE a.s., www.2n.cz
character is received.
is able to detect the continuous, busy and ringing tones even if
ST
plays back the "Attention, your
68/82

Advertisement

Table of Contents
loading

Table of Contents