Axis 2n SingleTalk User Manual page 45

If the cabin wall is inaccessible from the rear, follow instructions on the next
3.
page. TIP: If you have pre-drilled corner holes, find four headless M4 screws of
the length of 30 mm in the package. Drive the screws into the holes on the rear
side of the audio unit and tighten as mentioned in item b) above. Though
unprovided with nuts, the screws fix the product reliably, preventing it from
sliding or turning.
Mounting Completion – withour rear access
Insert the hex wrench (included in the delivery) in the bottom unit edge hole;
1.
turn left about 10 times until it puts up resistance.
The window slides down by itself or with little assistance, showing its upper brim.
2.
Tilt the window forwards and remove.
3.
2N TELEKOMUNIKACE a.s., www.2n.cz 45/82