Axis 2n SingleTalk User Manual page 71

Tip
The switch can be used, for example, for resetting the lift Each switch
can be controlled with up to 10 variable passwords. A new feature is that
the password can be entered without asterisks too if it starts with 6 to 9,
or 0. (This limit applies to the use of Automatic dialing with
confirmation.)
ST Signalling Overview
ST uses variable signals to communicate with the operating personnel during
programming, calls, and so on. For an overview of the signals including meanings refer
to the table below:
SIGNAL
Long continuous
tone
"Attention, your
call is being
terminated"
2N TELEKOMUNIKACE a.s., www.2n.cz
NAME MEANING
Confirmation Sent during an incoming call to the line immediately after
off-hook (the calling party hears it).
Remote switch activation.
Rejection Whenever a non-programmed button is pressed.
Heard from the loudspeaker to signal line connection.
Sent during an incoming call instead of confirmation,
indicating that the
memory has been damaged.
Storing Remote switch activation end.
Hang-up Sent close before the call end (in all cases).
Deleting Sent during dialing memory clearing, or full initialization
Signals during an outgoing or incoming call that the
maximum call duration will elapse in 10 seconds.
ST has not been programmed or its
71/82