Non-Stop Service Instructions For Use - Axis 2n SingleTalk User Manual

4.2 Non-Stop Service Instructions for Use

DTMF Control during the Call
Where Automatic dialing with confirmation is enabled, it is possible to use tone dialing
during the call to control the
commands 1 to 5 are arranged in the order they are usually used in.
DTMF FUNCTION DESCRIPTION
char
It is a confirmation
successful. ST
sends out the confirmation signal and the call continues until the end of the timeout and
the following commands can be used
Message playback
necessary for the call!
Repeated playback
Call prolongation
ended earlier. It can be used repeatedly.
or
Call termination.
or
2N TELEKOMUNIKACE a.s., www.2n.cz
ST in accordance with the table below. For convenience,
notifying SingleTalk
mutes the message playback,
muting CAUTION: .
of the voice recording module for 1 message repetition
: the call is prolonged up to 30 seconds after this command in case it
(hereinafter referred to as
Now that the SW has been changed, it is no more
ST ) that the call was
69/82