GCC Technologies Jaguar V Series User Manual page 37

1. Keep your blade length as 0 before you start adjusting.
2. Test the blade holder first and then test the blade length by
pressing ENTER.
3. Keep the blade holder at the same position when you
perform blade holder and blade length tests.
4. When blade holder and blade length tests are finished, the
screen will show you to what degree (the unit of the value
following "CW" or "CCW" is "circle") and in which direction
[CW (clockwise) or CCW (counterclockwise)] you should
turn the adjustment knob.
EG, Turn CW 0.5 is telling you that you should turn the
knob for half a circle clockwisely.
The value on the screen will be 0.0 when the blade length is
perfect and no more adjustment needs to be made. You may
start cutting at this point.
To clear up buffer memory.
Set Smoothing To enable smooth-cutting function.
Cut
Over Cut To generate an overcut to facilitate weeding.
Set Tangential To enable the emulated tangential-cutting mode for thicker
Mode media types and small letter cuts.
Note: while the Offset value setting at 0.000 mm, "Set
Tangential Mode" will automatically be disabled.
Pouncing To make perforated patterns.
* In order to use this function, Pouncing tool must be installed.
* Before start pouncing, place pouncing strip on top of the
cutting pad to protect the cutting pad.
* Set the value as 0 mm to disable the pouncing mode.
* Pouncing tool is an optional item.
Panel Setup Accept setup command:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via software.
Control panel only:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via control panel of the cutter.
Factory Default To turn all parameters of the menu items to factory-default
settings.
Auto Unrolled To avoid paper jam and motor crash by automatically unroll
Media media (50cm and up) before cutting while enabled. .
* Auto-unroll only effects on roll/edge media.
* Using Single mode to size media will disable this function
automatically.
* If the length of the rolled media is less than 2 meters or the
weight is light, it is recommended to set this mode disabled.
Section Cut To divides the long plot data into sectional output jobs to gain
higher cutting quality and increase precision.
Users can set the section by registration marks or input the
value manually.
The Control Panel
[ DATA CLEAR ]
[ TOOL SELECT ]
[ MISC ]
3-7
Jaguar V User Manual
Enable
0.00mm-1.00mm 0.00mm
0.05mm/per step
Enable
0~200mm 0mm
Accept
setup
command
Enable
200mm
intervals