The Right-Hand Side - GCC Technologies Jaguar V Series User Manual

1.4.4 The Right-hand Side (Figure 1-4)
Figure 1-4
General Information
USB Connector
– used to connect the
cutting plotter to a computer through a
USB cable.
Ethernet Connector– used to connect your
cutting plotter to a local area network.
Serial Interface Connector (RS232C) –
used to connect the cutting plotter to a
computer through a serial interface cable.
AC Power Connector – used to insert the
AC power cord.
Power Switch for Cutting Plotter – On when
switches to [I]; Off to [O]
Fuse – 3 Amp.
Power Switch for Take up System – On when
switches to [I]; Off to [O]
1-4
Jaguar V User Manual