GCC Technologies Jaguar V Series User Manual page 34

Offline For System Setup
[ TOOL SELECT]
[ MISC]
The Control Panel
1S:72 F:80 O:0.275 M
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Set Tangential Mode
Select: OK:ENTER
Pouncing 0 mm
Select: OK:ENTER
Panel Setup
Select: OK:ENTER
Factory Default ?
Select: OK:ENTER
Auto Unrolled Media
Select: OK:ENTER
Section Cut
Select: OK: ENTER
Die/Kiss Cut: ON
Select: OK:ENTER
Rear Paper Sensor
Select: OK:ENTER
Vacuum
Select: OK:ENTER
DHCP
Select: OK:ENTER
IP Address
Select: OK:ENTER
MAC Address
00:CF:52:72:03:01
First Back To Origin
Select: OK:ENTER
AAS Copy
Select: OK:ENTER
AAS Offset
Select: OK:ENTER
Paper Saving Mode
Select: OK:ENTER
Set communication
Select: OK:ENTER
Firmware x.x.xx
FPGA: xx.xx
Select Language
Select: OK:ENTER
3-4
Jaguar V User Manual
OverCut: 0.00~1.00mm with an
increment of 0.05mm
Pouncing: 0~200mm with an
increment of 1mm
Cancel Restore
Change:
Sure to Restore
Change:
Enabled, Disabled
OFF
Change:
ON
Change:
Die/Kiss Cut:
Length: 9.0 / 0.2 mm
Die/Kiss Cut:
Enabled, Disabled
Force: 450 g
Enabled, Disabled
Enabled, Disabled
IP Address set, Submask set,
Gateway set
Enabled, Disabled
Enabled, Disabled
Both Expanded Mode, Length Expanded Mode,
Width Expanded Mode, Both Un
English, Francais, Türkce, Polski, Japanese,
Deutsch, Italian, Espanol
OK: ENTER
OK: ENTER
OK: ENTER
OK: ENTER
45 g
e
xpanded Mode,