Table of Contents
Advertisement
To set or modify the distance between the blade tip and the
center axis.
To set or modify the value of tool force.
For Jaguar V_R, when the cutting force exceeds 450g, the
maximum cutting speed would be 15cm/sec and the cutting
quality would be Small Letter Mode (0.2g) and while the
cutting force is 300g-449g, the maximum cutting speed would
be 30 cm/sec and the cutting quality would be Fine Mode
(0.5g)
Speed
To set or modify tool speed at horizontal moving.
Quality
To set or modify cutting quality.
While cutting small letter, set as "Small letter".
While cutting in high speed, set as "Draft".
For normal operation, set as "Normal".
Up Accel.
To set or modify tool acceleration levels while the tool move
from endpoint to next start point at horizontal moving.
Up Speed
To set or modify tool speed while the tool move from endpoint
to next start point at horizontal moving.
Square Cut
To perform a cutting test at present blade position.
For more information, please refer to "4.3 Adjusting the
Cutting Force and Offset" to adjust blade force and cutting
speed.
Redo Jobs in
To redo the cut test jobs saved in memory by recutting or
Memory
producing cut test copies. Recut number: 0 means limitless. If
you want to set number as 0, you should set that between
repowering the cutter and putting down the lever.
To repeat AAS jobs automatically without having to operate
Repeat AAS
on the computer side.
Job
Please be noted that this feature is mainly applied to the
Single paper mode; please ensure a new piece of material
you wish to apply this feature on is loaded and the origin
repositioned to the first registration mark before starting.
When the first AAS job repeat completes, the user will be
offered the choice of "Repeat AAS Job Again", please
press "Online/Offline" to return to the main menu.
This option will appear after finishing reading all registration
marks.
Pattern Setting
To provide two patterns for cut test
Note: It is recommended to select "Cross" if you are working
on thick pieces of materials.
Ratio Setting
To adjust the size of the pattern
Blade Length
Please see 2.5 Automatic Blade Length Adjustment for
Adjust
further details.
To adjust the length of the blade
Note:
The Control Panel
[ FORCE ]
[ SPEED ]
[ CUT TEST ]
3-6
Jaguar V User Manual
0.000~1.000mm 0.275mm
5~600gram;
80 gram
5 gram/per step
3~153cm/sec;
72cm/sec
3cm/sec per step
Draft, Fair,
Normal
Normal, Fine,
Small Letter
High, Medium,
Medium
Low
3~153cm/sec;
72cm/sec
3cm/sec per step
Recut (number of
Recut
jobs: 0-99)
Copy (number of
jobs: 1-999)
"Arrow" and
"Arrow"
"Cross" patterns
Note: the
default
pattern for
Jaguar
V_R is
"Cross"
100%, 200%,
100%
300%, 400%
0.00mm-5.00mm 0.00mm
Hide quick links:
Advertisement
Table of Contents
